I attended Paul Rabinov’s Muramatsu FLute Workshop in Los Angeles where I became a Certified and Licensed Technician for Muramatsu Flutes,
This is a pliers used to pull out flute pins. One must be careful not to cut the end of the pin off however.
This is jewelers or watchmakers lathe. Its uses are only limited by the imagination.
These are a complete set of collets used to hold screws, tools, whatever needs to be held tightly while spinning in the lathe.
You can never have too many tools, files, a jacobs chuck, drills.
his is a set of collets used to round or reshape flute head joint and foot tenons.
Here is the collet installed in a much larger lathe as the inside diameter of the collet is a little larger than 3/4".
Rounding out the tenon the fit on the flute foot joint.
pause | resume | previous | next (16 of 20)
This item can be used to absorb moisture and dirt from the flute pads. Just put in between the pad and tone hole, gently close and pull out.
This item can be used to absorb moisture and dirt from the flute pads. Just put in between the pad and tone hole, gently close and pull out.